search

space10-community / the-growroom

782 stars 148 forks source link

Number of 18mm Plywood Sheets Needed #9

Closed EJN1 closed 7 years ago

EJN1 commented 7 years ago

The Manual specifies 13 sheets of 18mm plywood but the .dxf file only seems to show 12. What am I missing - Thanks

silicakes commented 7 years ago

IMO, it seems like you'll be cutting several parts from each sheet - so it consolidates into less than 13.

cwiegman commented 7 years ago

I started actually making the Growroom and before heading out to purchase the remaining 7 boards, I noticed this 12 v 13 difference too. So I made a count of parts that will be made from the dxf vs the milled diagram that we should have, and I could be wrong but I think 13 boards is the correct number. I will let you know if i am but I notice only one of the F'circle parts missing, so only half a board is needed. My plan is to actually change some of the nesting with ~80 wedges, placing them on the scrap areas of other boards, copy a 5th F into that freedup space and and only use 12 boards.

HusumLindholm commented 7 years ago

Hi all,

It is true that you only need 12 sheets of 18mm plywood. Regarding the missing F piece, the drawings have been updated and include all pieces - still on 12 sheets. Further more we have cleaned up the lines, so the files now consist of arcs and lines only, with much fewer control points. Furthermore we have uploadet a package that include each sheet in single files with numbers.

Best regards Husum&Lindholm