Open SpaceShawn opened 8 years ago
The Kenwood resetting problem can be fixed by unplugging the power cable and running only on battery power.
Proven TX/RX capabilities summary
Source | TX | RX |
---|---|---|
Kenwood | 144.2, 431 | 431 |
ICOM | 431 | 144.2, 431 |
He100 | 431 | 144.2 |
Tested transmissions
Src. -> Dest. | TX Freq | Result |
---|---|---|
Kenwood -> ICOM | 144.2 MHz | working |
ICOM -> Kenwood | 431 MHz | working (some lost frames) |
ICOM -> Kenwood | 144.2 MHz | working |
Kenwood -> He100 | 144.2 MHz | working |
He100 -> Kenwood | 431 MHz | working |
ICOM -> He100 | 144.2 MHz | not working |
He100 -> ICOM | 431 MHz | working (on both sub band and main band) |
The He100 was configured as follows:
Interface Baud Rate: 9600 [0]
TX Power Amp Level: 0 [0]
RX Baud Rate: 9600 [1]
TX Baud Rate: 9600 [1]
RX Frequency: 144200
TX Frequency: 431000
LED: OFFLOGICLOW [00]
PIN13: OFFLOGICLOW [00]
PIN14: OFFLOGICLOW [00]
RXCRC: OFF [00]
TXCRC: ON [01]
TELEMETRY: OFF [00]
TELEMETRY RATE: 1/10 Hz [00]
TELEMETRY DUMP: OFF [00]
BEACON OA COMMANDS: OFF [00]
CODE UPLOAD: OFF [00]
CODE RESET: OFF [00]
Source Callsign: VA3ORB
Destination Callsign: VE2CUA
TX Preamble: 1280
TX Postamble: 0
EXT: All Functions off [00]
Function Config2 [00][00][00][00]
Transmitting on 144.2 MHz from the ICOM can not be received by the Kenwood or the Helium100.
Transmitting on 431.0 MHz can be received by the Kenwood, but not the Helium100 since it can only listen on 144.2 MHz
The Kenwood resets every time you try to transmit now.
Working
See the wiki for specific configuration