Closed GoncaloFelicio closed 5 years ago
Hi there, it sounds like you are looking for technical assistance. Unfortunately, this is not the place to get technical support; it is for filing problems with the code, library, or hardware. Use the link (above), to get started with posting a topic in our forums. Our technical support team will do their best to assist you.
That being said, please check out the guides associated with this product:
Hi! I would like to know more about calibration. Is specific, does the setup influence the calibration factor, or is the calibration factor a number i get from the calibration sketch and then i always use that same calibration factor?
In my case, i want to setup 4 loadcells to the same wood board, but can i calibrate before i screw them to the board, or can i only calibrate after i have my setup?
Thanks!