1) Needs fiducials
2) Needs short dash style on division lines in sch
3) Version # in sch is v01, and on board it's v10. Since this is a proto, should be v01 on both.
4) Add VCC range note to sch
5) take the "Ohm" out of each resistor value
6) Board dimension should be 0.008 inch (not 0.010)
JoelEB
commented
9 years ago
1) Needs fiducials 2) Needs short dash style on division lines in sch 3) Version # in sch is v01, and on board it's v10. Since this is a proto, should be v01 on both. 4) Add VCC range note to sch 5) take the "Ohm" out of each resistor value 6) Board dimension should be 0.008 inch (not 0.010)