Hi, recent purchaser of SP801e. Works great normally, however when set up to use Artnet Mode it does not auto restart recieving data upon power on /off.
I.E.
1) Working fine receiving continuous signal
2) Disconnect power
3) Reconnect
4) LEDs stay blank
5) Connect to device on BanlanX - still shows Artnet Mode active - but no signal being sent to LEDs anymore
6) Only solution currently is to slightly modify some of the Artnet settings or to switch back to regular,then back to Artnet , either of which then seem to cause it resume recieving signal and LEDs start working again.
This is extremely inconvenient if you have to open the app to get it working every single time power is turned off. It seems like a firmware bug as it acts like it still thinks it is doing Artnet on the app, just not in reality.
Hi, recent purchaser of SP801e. Works great normally, however when set up to use Artnet Mode it does not auto restart recieving data upon power on /off.
I.E. 1) Working fine receiving continuous signal 2) Disconnect power 3) Reconnect 4) LEDs stay blank 5) Connect to device on BanlanX - still shows Artnet Mode active - but no signal being sent to LEDs anymore 6) Only solution currently is to slightly modify some of the Artnet settings or to switch back to regular,then back to Artnet , either of which then seem to cause it resume recieving signal and LEDs start working again.
This is extremely inconvenient if you have to open the app to get it working every single time power is turned off. It seems like a firmware bug as it acts like it still thinks it is doing Artnet on the app, just not in reality.