search

springbok / MLM2PRO-GSPro-Connector

GSPro Connector for the MLM2PRO Launch Monitor
GNU General Public License v3.0
49 stars 6 forks source link

Chip with a ball speed of 19 reading as 193 #55

Closed jjmanthei05 closed 9 months ago

jjmanthei05 commented 11 months ago

I have had multiple chips last night that registered as 19 for ball speed but came through gspro as 193.

springbok commented 11 months ago

This is a result of the OCR misreading and adding an extra digit, I try and correct this as much as possible but in some cases like these it’s not possible as the ball speed falls below the threshold. Not much I can do about it other than tighten the threshold but then I will be correcting genuine ball speeds.

Sent from my iPhone

On 5 Dec 2023, at 5:42 am, jjmanthei05 @.***> wrote:

 I have had multiple chips last night that registered as 19 for ball speed but came through gspro as 193.

— Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you are subscribed to this thread.

wonder99 commented 11 months ago

I was wondering if he's using an older version of the connector, before some of the metric manipulation was improved? Paul

On Mon., Dec. 4, 2023, 2:55 p.m. Etienne van Tonder, < @.***> wrote:

This is a result of the OCR misreading and adding an extra digit, I try and correct this as much as possible but in some cases like these it’s not possible as the ball speed falls below the threshold. Not much I can do about it other than tighten the threshold but then I will be correcting genuine ball speeds.

Sent from my iPhone

On 5 Dec 2023, at 5:42 am, jjmanthei05 @.***> wrote:

 I have had multiple chips last night that registered as 19 for ball speed but came through gspro as 193.

— Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you are subscribed to this thread.

— Reply to this email directly, view it on GitHub https://github.com/springbok/MLM2PRO-GSPro-Connector/issues/55#issuecomment-1839375209, or unsubscribe https://github.com/notifications/unsubscribe-auth/ABIZTO34CB7BXKSHY3JCE3DYHYTBPAVCNFSM6AAAAABAGOF47OVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTQMZZGM3TKMRQHE . You are receiving this because you are subscribed to this thread.Message ID: @.***>

jjmanthei05 commented 11 months ago

Sorry meant to post in the original issue log. I am on the most current version of the connector. if there is nothing that can be done, that is fine. Just wanted to post in case this wasn't known.

springbok commented 11 months ago

Are you using Android or iOS?

I have a new version I will release in the next day or two, you can download and try it to see if it improves things for you:

https://1drv.ms/u/s!Agx7aYfjrZJ8oGhnFYzyiFwlba5Q?e=0kaI8w

jjmanthei05 commented 11 months ago

I am using IOS. I will download to check it and let you know. Thanks for the quick response.

springbok commented 9 months ago

There is anew beta release that have worked well for everyone thus far:

https://1drv.ms/u/s!Agx7aYfjrZJ8omovE3iQwJ63ENES?e=VOjpP4