search

stacksmashing / pdnd-picoprobe

A fork of Picoprobe, an SWD progammer firmware, for the Pico Debug'n'Dump
20 stars 4 forks source link

Wiring instructions could use some tweaks #3

Open anyconhhv opened 3 years ago

anyconhhv commented 3 years ago

I'm having some questions on the wiring, The documentation isn't clear. Some minor corrections would be useful.

  1. The github docs and the store don't mention https://pdnd.stacksmashing.net/ I didn't see this until after I started soldering. A reference to this link in the package, the store, or the source would be appreciated.
  2. The wiring for the display is not clear. It says I can solder the pairs pin1 or pin2 depending on the type of display, but it never says how to tell the different between displays and which pins to solder once I determine the type.

I'm going to short one pair out and measure the voltages, but it would be handy if this was documented.

Thanks

.

anyconhhv commented 3 years ago

Ah. I see. There 4 pairs of pads for wiring up the display. You select either Vcc or Gnd for both pin 1 and pin 2.