GPIO configuration from the web UI interface

[PetrJakes]

It would be great if there is a possibility to set up the GPIO pin(s) for input impulses and for output impulses (testing mode) in teh web UI interface.

[steadramon]

Hi there, this is something I have considered, especially since building is now automatic through github.

[PetrJakes]

Tasmota firmware has it for long time and I found it very useful.

On Mon, Jun 19, 2023 at 9:16 PM steadramon @.***> wrote:

Hi there, this is something I have considered, especially since building is now automatic through github.

— Reply to this email directly, view it on GitHub https://github.com/steadramon/ESPGeiger/issues/1#issuecomment-1597642858, or unsubscribe https://github.com/notifications/unsubscribe-auth/AC77XC36Q4K3LYHGB37TQZTXMCQPFANCNFSM6AAAAAAZKOTO3A . You are receiving this because you authored the thread.Message ID: @.***>

[krotoniec]

Definitely GPIO config would be something very useful.

[realatomisator]

Thank you very much for this great project. Unfortunately I have Problems with an 38 PIN ESP32 and a cajoe v1.1. A GPIO config in the Setup would be helpful. Thanks a lot!

[steadramon]

The latest pushes to main has this ability. I will test further and look to make a release

[realatomisator]

Thank you very much. With the new 0.39 release it works fine!!!