Sonoff 4CH (not pro)

[wunderbaum]

<<<<<<< HEAD

IMPORTANT NOTICE If you do not complete the template below it is likely that your issue will not be addressed. When providing information about your issue please be as extensive as possible so that it can be solved by as little as possible responses.

FAILURE TO COMPLETE THE REQUESTED INFORMATION WILL RESULT IN YOUR ISSUE BEING CLOSED

8f585b7f5354b19aff4bc6d1f238df4588d5693f Make sure these boxes are checked [x] before submitting your issue - Thank you!

• [x] Searched the problem in issues (https://github.com/arendst/Sonoff-Tasmota/issues)
• [x] Searched the problem in the wiki (https://github.com/arendst/Sonoff-Tasmota/wiki/Troubleshooting)
• [x] Searched the problem in the forum (https://groups.google.com/d/forum/sonoffusers)
• [x] Searched the problem in the chat (https://discord.gg/Ks2Kzd4)
• [x] Hardware used : Sonoff 4CH
• [ ] If a pre-compiled release or development binary was used, which one? : one from folder
• [ ] You have tried latest release or development binaries? :
• [ ] Provide the output of command status 0 :

  STATUS 0 OUTPUT HERE: No output, is dead.

I had used the original tasmota on a sonoff 4ch for 2 blinds. I configured it with interlock 1,2 3,4. That worked good but was not good to implement in home assistant.

Today, I tried to flash OTA this version of tasmota. Uploading the minimal-firmware worked, but after uploading the firmware_sonoff, the deviced dissapeared and I have no idea what happend. Do I need to open the cupboard and get it out or what could I do? What have I done wrong?

(Please, remember to close the issue when the problem has been addressed)

[wunderbaum]

Pooh, lucky me. That was a result of a quick idea during a boring lunch break. Coming home, the device was started but had lost the complete setup. So, if someone hops from Teos Tasmota to this version, the device is virgin again and needs configuration. Therefore I do not recommend to do an OTA-update while hanging around 90km from home.