search

stefanbode / Sonoff-Tasmota

Provide ESP8266 based itead Sonoff with Web, MQTT and OTA firmware using Arduino IDE, enhanced with I2C options
GNU General Public License v3.0
128 stars 41 forks source link

upgrading from Sonoff-Tasmota 6.5.0.11 stb-1.5 by Theo Arends #221

Closed adizag closed 2 years ago

adizag commented 2 years ago

Hi @stefanbode

I'm using your firmware for a very long time, but I'd like to upgrade to the main tasmota now after you migrated your great work in there. Can you please advise abour upgrading method from Sonoff-Tasmota 6.5.0.11 stb-1.5 ?

tnx!

stefanbode commented 2 years ago

Yes, please export your settings first. Then follow the upgrade procedure for like you have normal tasmota 6.5 version. There are some updates with the -minimal version required until you can go to version 10.

stefanbode commented 2 years ago

Migrate to Sonoff-Tasmota 6.7.1 (http://ota.tasmota.com/tasmota/release-6.7.1/) Migrate to Tasmota 7.2.0 (http://ota.tasmota.com/tasmota/release-7.2.0/) --- Major change in parameter storage layout ---

Migrate to Tasmota 8.5.1 (http://ota.tasmota.com/tasmota/release-8.5.1/) --- Major change in internal GPIO function representation ---

Migrate to Tasmota 9.1 (http://ota.tasmota.com/tasmota/release-9.1.0/)

adizag commented 2 years ago

well... that didn't go well.... I upgraded to 6.7.1 then the switch became unavailable, not responsive to touch also... I believe I'll have to flash the firmware again....

adizag commented 2 years ago

So I flashed from scratch, but im unable to restore from backup... any idea?

image

adizag commented 2 years ago

@stefanbode OK, I recovered the switch (phew, there were many changes from your fork to the main Tasmota!) Now it is working nice.

  1. One feature is missing and I couldn't find how to config it: when the shutters are opening e.g. and I press the Down button it stops. I want the shutters to change direction in that case as it was in your fork. How do I do that please?

  2. any idea why the upgrade didn't work properly and how I will be able to do it easily for all other modules OTA?

adizag commented 2 years ago

Solved it - I had to command reset 6 before I started the upgrade. Now everything is great. tnx.

stefanbode commented 2 years ago

There a different command for every use case. You can assign buttons to the commands. Take a look into the very long documentation