GPS and ProSeed combination

[JuniorKDK]

The tramline from ProSeed should in the GPS-Mode be on the line 0. This will bring several good effects.

1. For each field, you only need one GPS-line, witch can use for drilling, fertilizing, harvesting, etc.
2. When you switch from positive to negative fieldlines on one field, there was a big gap between the tramlines in FS19, with the tramline on line 0, this gap wouldn´t exist.

[JuniorKDK]

For the first time I use two different working width for pneumatic seed drill and precision seed drill. In this case, my suggestion would be even more effective, since you cannot get any further by simply changing line 0 with ALT+Home and adjusting the working width with ALT+R. In addition, one would certainly save calculations in the script if the script does not have to calculate the middle line but simply has to increase the number of lines to the next tramline.

[Snickers125]

The tramline from ProSeed should in the GPS-Mode be on the line 0. This will bring several good effects.

1. For each field, you only need one GPS-line, which* can be used* for seeding*, fertilizing, harvesting, etc.

2. When you switch from positive to negative fieldlines on one field, there was a big gap between the tramlines in FS19, with the tramline on line 0, this gap wouldn´t exist.

1. actually you only need one GPS direction right now, just adjust the working width and you are fine? ( just reset your GPS at the tramline and it will turn into row number 0)
2. see above

[JuniorKDK]

@Snickers125 See my second comment. I know that it works so, but it's more complicated than in reality and with different working widths it just gets more and more complicated. The clean solution would be the best. I currently have five widths that must/should match each other. 6m potato planter 9m precision seeder 12m seeder 18m lime spreader 36m field sprayer