Assemble power supply enclosure and install on wall shelf near Bay 2 filter panel. This power supply will be used to power Don's PIN diode driver boards on coils inside the magnet bore.
It would also be good to install feedthrough capacitors on the filter panel to provide power to the shim amplifiers inside the magnet room. Jason has all the parts in the RF Lab. Some holes need to be drilled in the filter enclosure itself and also in the filter panel at the bay. It's a two-person job since someone needs to hold the enclosure up on both sides.
Assemble power supply enclosure and install on wall shelf near Bay 2 filter panel. This power supply will be used to power Don's PIN diode driver boards on coils inside the magnet bore.
It would also be good to install feedthrough capacitors on the filter panel to provide power to the shim amplifiers inside the magnet room. Jason has all the parts in the RF Lab. Some holes need to be drilled in the filter enclosure itself and also in the filter panel at the bay. It's a two-person job since someone needs to hold the enclosure up on both sides.
Work could be split between Jason and Lincoln.
(not really sure where to put this issue)