Closed cbjfan2009 closed 1 month ago
Power the pi and access it via web broswer, change the config to 11.00 from 10.50
My initial RPi setup, I told PI-Pwn that I was on 10.50. After success, but no GoldHEN access, I updated firmware to 11.00 to be in-line with "the standard in all the guides and tutorials."
Now, I just get PS4 crash after crash. Do I need to edit some configuration to let the Pi-Pwn script target 11.00 firmware instead of 10.50?
Maybe this can be deleted. I interrupted the script and went back to command and re-installed using 11.00 at the prompt. However, no I'm hung up on "Link Found" permanently.
Just to mention the original issue was that they tried using goldhen.bin (from what i understood on reddit) on 10.50 firmware which currently does not have goldhen support. After updating to 11.00 they had the Link Found/ No IP issue which was caused by them not putting in the PPPoE username and password as "ppp" here on reddit is the full conversation. https://www.reddit.com/r/ps4piracy/comments/1eztbnl/cross_post_from_homebrew_sub_but_having_issues/
Issue has been resolved.
re run the install commands used to install pi-pwn and change the settings or use the web ui to change them.
My initial RPi setup, I told PI-Pwn that I was on 10.50. After success, but no GoldHEN access, I updated firmware to 11.00 to be in-line with "the standard in all the guides and tutorials."
Now, I just get PS4 crash after crash. Do I need to edit some configuration to let the Pi-Pwn script target 11.00 firmware instead of 10.50?
Maybe this can be deleted. I interrupted the script and went back to command and re-installed using 11.00 at the prompt. However, no I'm hung up on "Link Found" permanently.