search

storyboardcreativity / Z-Camera-E1-Reverse-Engineering

Z Camera E1 firmware reverse-engineering results.
38 stars 12 forks source link

turn on wifi / clear settings #4

Open q3o opened 3 years ago

q3o commented 3 years ago

Hi, is there any change to use the autoexec.sh to turn on wifi or clear settings on startup? My back screen is not working and neither are the buttons, so I need access thru wifi to setup everything but unfortunately is down. Thanks

mados123 commented 3 years ago

I can't believe I found someone with the same exact need! My back screen isn't working either and I need the Wifi turned on as well or have the settings cleared. Tech support from Zcam says to send it back to Hong Kong for "the camera to be repaired". I would like to rule out there's a simple fix that can be done by your request above.

mados123 commented 3 years ago

I am in contact with their Zcam's tech support and they said that if the test mode shows a blank back screen, there is a problem with the screen (and not just turned off in the settings). Test mode is achieved by hitting the shutter/red button on top+menu+power during bootup. To exit Test mode, just power down with the power button. Playing around in there can mess things up - I guess worse than it already is.

They are suggesting I send it back for repairs and I won't know the cost to repair it until they receive it. Not a proposition I like.

Hopefully these details can help you or Storyboard. I'm still very curious if they can create an autoexec.asc to turn on wifi or clear settings on startup.