ToMadoRe
commented
10 years ago Here the settings (based on loaded default values) from Metralabs in case anyone needs it in the future:
BIOS MI956
Stand: 2013-08-29
"Main" Datum: prüfen + ggf korrigieren Zeit: prüfen + ggf korrigieren
"Advanced" 'PCI Subsystem Settings': default
'ACPI Settings' : default
'Wake up event setting' : default
'CPU Configuration' : default
'SATA Configuration' SATA Controllers : default SATA Mode Selection : ->AHCI Rest : default
'Shutdown Temperature Configuration' ACPI Shutdown Temperature : ->95 C/203 F
'EuP/ErP Power Saving Controller': default
'DPTF Configuration' DPTF: -> Enabled Rest: default
'Acoustic Management Configuration' default Automatic Acoustic Management: default
'USB Configuration' Legacy USB Support: Enabled USB3.0 Support: Enabled XHCI Hand-off: Enabled EHCI Hand-off: Enabled USB transfer time-out: 20 sec Device reset time-out: 20 sec Device power-up delay: Auto
'F81865 Super IO Configuration' -> default
'F81865 H/W Monitor' -> nur Anzeige
'CPU PPM Configuration' EIST: Enabled Turbo Mode: Enabled
'Sandybridge DTS Configuration' CPU DTS: -> Enabled
"Chipset" 'PCH-IO Configuration' 'PCI ExpressConfiguration': default 'USB Configuration': default 'PCH Azalia Configuration' Azalia -> Disabled PCH LAN Controller: default Wake On LAN: default Board Capability: default High Precision Timer: default SLP_S4 Assertion Width: default
'System Agent (SA) Configuration' VT-d: default CHAP Device: default Thermal Device: -> Enabled Enable NB CRID: default BDAT ACPI Table Support: default 'Graphics Configuration' Graphics Turbo IMON Current: default Primary Display: default Internal Graphics: default GTT Size: default Aperture Size: default DVMT Pre-Allocated: default DVMZ Total Gfx Mem: default Gfx Low Power Mode: default 'LCD Control' Primary IGFX Boot Display: default LCD Panel Type: default Active LFP: -> Int-LVDS Panel Color Depth: default 'Memory Configuration' read-only
"Boot" -> default
"Security" -> default
I'd need some help for the BIOS settings. After disabling the USB 3.0 support in BIOS (Advanced - USB Configuration - USB 3.0 Support - Disable), these ports are disabled completely. Neither Keyboard nor ASUS Xtion are working when plugged into the blue USB ports with this setting.
I then tried to change few other settings in the BIOS in the hope that the USB bus gets separated from the CAN bus. However without any success. I ended up trying to restore the BIOS defaults, which wasn't too clever I assume. Now I can only work with an external monitor as the touchscreen monitor stopped working (only white background light) and persisting USB problem.
Can anyone tell me how to configure the BIOS correctly (given the default settings)? Or is there anyone I could ask from Metralabs?