search

sudomesh / disaster-radio

A (paused) work-in-progress long-range, low-bandwidth wireless disaster recovery mesh network powered by the sun.
https://disaster.radio
1.06k stars 108 forks source link

How add password to Wifi and HTTPS #89

Open zerotrzy opened 4 years ago

zerotrzy commented 4 years ago

Hello,

I flash my device with disaster-radio-1.0.0-rc.1 ttgoV2_flash.bin How add password to wifi connections (and meybe disable BLE) ?

I can create a firmware i cloning this repo cd to firmware and $pio run I get firmware.bin but it is very small

original

`-rw-r--r--. 1 itt itt 4194304 04-14 16:13 ttgoV2_flash.bin

`my firmware

-rw-rw-r--. 1 itt itt 1755456 09-10 14:25 firmware.bin

How add password or compiling firmware on linux?

BishopPeter1 commented 4 years ago

compile firmware: pio run -t upload pio run -t uploadfs

and maybe is better befor cupload to board: esptool.py --baud 921600 erase_flash

https://github.com/sudomesh/disaster-radio#building-firmware and https://github.com/sudomesh/disaster-radio#flashing-firmware

zerotrzy commented 4 years ago

@BishopPeter1 You sugest run $pio run -t upload but How creating firmware similar normal distro? My compilation are smalest than normal compilation. It will not work. This is a problem. My compilation is completly different than oficial 1.0.0.

paidforby commented 4 years ago

Hey @zerotrzy, I built that binary by flashing a ttgo-lora32 board using pio run -t upload and then copying the flash memory from it, you can follow these instructions to create a binary, https://github.com/sudomesh/disaster-radio#creating-binary-for-release. However, if what you are trying to do is add a password to the wifi, you have need to add the code to do that before building and flashing the firmware. I think this feature would need to be added around this line https://github.com/sudomesh/disaster-radio/blob/master/firmware/main.ino#L145 . I don't remember the exact syntax for setting a password in AP mode.