Open ppartarr opened 3 years ago
Okay after a long debugging session, it seems like mySwitch.setProtocol(3);
is simply the wrong protocol to use for the brennenstuhl RC CE1 4001 even though the captured protocol is clearly 3...
This user on a german arduino forum [1] is using the same model as I am and managed to get it working by setting the protocol to 4. I can confirm that this also worked on my end.
Although I'm glad my issue is solved I'm still puzzled as to why the receiver was showing protocol 3 when sniffing the controller's messages and why replaying the same message would not work...
[1] https://forum.arduino.cc/t/brennenstuhl-rc-ce1-4001-433mhz-kein-vorankommen/493589
I have a very similar and weird issue; the pulse length that I set (176) is not what is transmitted (352). Everything else looks to be transmitted to what I set it to do (Decimal code, Binary code, Protocol number) except for the Raw data that looks different too.
Why is this happening?
Equipement
I'm using an FS1000A transmitter & XY-MK-5V receiver to control the brennenstuhl RC CE1 4001 set
Problem
Sniffing the controller's signal whilst repeatedly pressing the ON button for the A channel will cycle through these 4 messages:
I am therefore using the arduino sketch below to activate the switch with the sender
And this results in the following messages:
As you can see, the received pulse length is 512 instead of the 100, and the protocol is 5 instead of 3. The received values show that the sender is using the wrong protocol and the wrong pulse length even though they have been correctly defined. The switch is therefore not turning on.
Any ideas on why the library isn't working as intended?