First of all sorry because my english is not good.
I just tried to send raw data using a protocol and I saw that the sync bit of the protocol is sent after the code instead of sending it before the code (code still works if setRepeatTransmit>1 because the sync code of one transmit is used on the next) .
Is just my protocol that needs sync bit at first?
I just changed this:
void RCSwitch::send(unsigned long code, unsigned int length) {
if (this->nTransmitterPin == -1)
return;
#if not defined( RCSwitchDisableReceiving )
// make sure the receiver is disabled while we transmit
int nReceiverInterrupt_backup = nReceiverInterrupt;
if (nReceiverInterrupt_backup != -1) {
this->disableReceive();
}
#endif
for (int nRepeat = 0; nRepeat < nRepeatTransmit; nRepeat++) {
this->transmit(protocol.syncFactor); //ADDED------------------------------------------------------
for (int i = length-1; i >= 0; i--) {
if (code & (1L << i))
this->transmit(protocol.one);
else
this->transmit(protocol.zero);
}
// this->transmit(protocol.syncFactor); //DELETED----------------------------------------------------
}
// Disable transmit after sending (i.e., for inverted protocols)
digitalWrite(this->nTransmitterPin, LOW);
#if not defined( RCSwitchDisableReceiving )
// enable receiver again if we just disabled it
if (nReceiverInterrupt_backup != -1) {
this->enableReceive(nReceiverInterrupt_backup);
}
#endif
}
Hi,
First of all sorry because my english is not good. I just tried to send raw data using a protocol and I saw that the sync bit of the protocol is sent after the code instead of sending it before the code (code still works if setRepeatTransmit>1 because the sync code of one transmit is used on the next) . Is just my protocol that needs sync bit at first?
I just changed this: