When using the Voron Calibration cube on the platter, it places it ~15mm lower than it should, so the bottom 15mm of the cube are below the build plate. Didn't notice the first time I ran it. All sorts of weirdness ensued as the "first layer" wasn't the first layer so it was just the infill and perimeter on the build plate, no "bottom" per se... Lifting it up so it falls to the plate properly fixed the problem. Haven't played with other calibration pieces.
Version
2.4.58.5
Operating system type + version
Win10
Behavior
When using the Voron Calibration cube on the platter, it places it ~15mm lower than it should, so the bottom 15mm of the cube are below the build plate. Didn't notice the first time I ran it. All sorts of weirdness ensued as the "first layer" wasn't the first layer so it was just the infill and perimeter on the build plate, no "bottom" per se... Lifting it up so it falls to the plate properly fixed the problem. Haven't played with other calibration pieces.
Is this a new feature request? NO
Project File (.3MF) where problem occurs
Built-in.