search

supermerill / SuperSlicer

G-code generator for 3D printers (Prusa, Voron, Creality, etc.)
4.03k stars 516 forks source link

Infill, Advanced, Only retract when crossing perimeter - threshold too far outwards #4294

Closed CuredPrusa closed 1 week ago

CuredPrusa commented 3 weeks ago

Version: 2.5.60.0 Build: SuperSlicer_2.5.60.0_2024-05-21 Operating System: Windows System Architecture: 64 bit Windows Version: Windows 10 (build 19045), 64-bit edition

"Infill, Advanced, Only retract when crossing perimeter" - doesn't retract when travel line is on the edge. It leaves visible lines on otherwise smooth wall surface of the model. Workaround: I change infill density, travel line gets another exiting point, slicer recognizes "outside perimeter" and retracts. That works, but after a wasted print which didn't pass quality check. I think slicer should retract before leaving the travel marks on the model surface for being to close to the outer perimeter.

image image

supermerill commented 3 weeks ago

can i have your project file?

CuredPrusa commented 3 weeks ago

Here it is. Problem is at layers 348-371 test4.zip