Closed poudenes closed 1 week ago
Hi All,
I was trying to use the calibration tool in SuperSlicer There are some with 2 different tests:
For both calibrations the names are the same. Would be nice to see this into
This makes it easy to store the Gcode files and use them again.
The its not clear where you put the Over Bridge and Top flow when printing is done. There are some options:
Greetings, Peter
Hi All,
I was trying to use the calibration tool in SuperSlicer There are some with 2 different tests:
For both calibrations the names are the same. Would be nice to see this into
This makes it easy to store the Gcode files and use them again.
The its not clear where you put the Over Bridge and Top flow when printing is done. There are some options:
Greetings, Peter