Open Tinchus2009 opened 3 years ago
"Toolchange temperature" is the temp for extracting the current filament from the nozzle.
So where do you setup the standby temperature for a dual extrusion? In #674 you said the stand by temperature was set with Toolchange temperature.
mmm.... can you post your project file, and the lines that are wrong in the gcode?
I have questions about setup of dual extruder as well.
Version
2.2.53 stable
Operating system type + version
win10
3D printer brand / version + firmware version (if known)
custom corexy reprapfirmware dual extruder printhead
Behavior
Im setting up a dual extrusion print and trying to setup the PVA parameters. The Toolchange temperature value, Im trying to set it up to 120 degrees, but it always defaults me to 175, wich is too high (pva ca even be printed at that temp)