Open suthiporn opened 6 years ago
อธิบายหลักการทำงาน ทำการ copy ค่าที่ได้ลง exel และแสดงผลเป็นกราฟ
Source code
// Uncomment whatever type you're using! //#define DHTTYPE DHT11 // DHT 11
//#define DHTTYPE DHT21 // DHT 21 (AM2301)
// Connect pin 1 (on the left) of the sensor to +5V // NOTE: If using a board with 3.3V logic like an Arduino Due connect pin 1 // to 3.3V instead of 5V! // Connect pin 2 of the sensor to whatever your DHTPIN is // Connect pin 4 (on the right) of the sensor to GROUND // Connect a 10K resistor from pin 2 (data) to pin 1 (power) of the sensor
// Initialize DHT sensor. // Note that older versions of this library took an optional third parameter to // tweak the timings for faster processors. This parameter is no longer needed // as the current DHT reading algorithm adjusts itself to work on faster procs. DHT dht(DHTPIN, DHTTYPE); const int led = 13;
void setup() { pinMode(led,OUTPUT); Serial.begin(9600); Serial.println("DHTxx test!");
dht.begin(); }
void loop() { // Wait a few seconds between measurements. delay(2000);
// Reading temperature or humidity takes about 250 milliseconds! // Sensor readings may also be up to 2 seconds 'old' (its a very slow sensor) float h = dht.readHumidity(); // Read temperature as Celsius (the default) float t = dht.readTemperature(); // Read temperature as Fahrenheit (isFahrenheit = true) float f = dht.readTemperature(true);
// Check if any reads failed and exit early (to try again). if (isnan(h) || isnan(t) || isnan(f)) { Serial.println("Failed to read from DHT sensor!"); return; }
// Compute heat index in Fahrenheit (the default) float hif = dht.computeHeatIndex(f, h); // Compute heat index in Celsius (isFahreheit = false) float hic = dht.computeHeatIndex(t, h, false);
Serial.print(h); Serial.print(" \t"); Serial.println(t);
if (t>=28) { digitalWrite(led, HIGH); } else{ digitalWrite(led, LOW); } }
#Lab5.txt
![5-2](https://user-images.githubusercontent.com/21135691/31065359-2411b32c-a70a-11e7-9bfc-88539f7fa83e.png)