search

sylvandb / gruvin9x

Automatically exported from code.google.com/p/gruvin9x
0 stars 0 forks source link

TX Power on ALERT: THR not idle #83

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago 
What Version of the firmware are you running?

Find this by entering the global menu using [LEFT-LONG], then advance to
Menu 3 - VERSION. * Please record at least the SVN data, E.G: "trunk-r38"

*SVN: trunk-r630
VERS: V1.2-gruvin (313)
DATE: 30.06.2011
TIME: 12:12:53

What steps will reproduce the problem?
1. Turned on the transmitter (TX)
2. Splashscreen is ok, then...
3. ALERT
THR not idle
        Press any key

What is the expected output?
No error as throttle is at lowest position and calibrated (-100)

What do you see instead? The alert as stated above.

What version of the product are you using? On what operating system?
N/A

Please provide any additional information below.
Pots cal'd up ok.

Original issue reported on code.google.com by argo.em...@gmail.com on 18 Dec 2011 at 8:53

GoogleCodeExporter commented 8 years ago 
Could you try to calibrate again? It's not normal! Perhaps you lost your 
calibration settings after an EEPROM write? Also, did you load the last stable 
gruvin9x version? Please keep me informed.

Original comment by bson...@gmail.com on 27 Dec 2011 at 4:22

GoogleCodeExporter commented 8 years ago 
The other thing that has got me a few times is the Tx stick mode. If you are a 
mode2 flyer for instance you will need to set that correctly before the warning 
responds correctly.

Original comment by th9...@gmail.com on 28 Dec 2011 at 1:16

GoogleCodeExporter commented 8 years ago 
No response from the OP on this and I can't duplicate the fault under any 
properly configured circumstances. So I'm marking this invalid.

Original comment by gru...@gmail.com on 30 Dec 2011 at 2:29