synman / Ender-3-S1-Pro-Firmware

Creality Ender-3 S1 Pro Firmware
148 stars 8 forks source link

UBL 100 Fails at point 28 - F4-s1pro - Octoprint #32

Closed MrDB42 closed 1 year ago

MrDB42 commented 1 year ago

When running bed leveling, the probe retracts at "Probing mesh point 28/100" and an error is thrown when connected via Octoprint.

Recv: //action:notification Probing Failed Recv: Error:Probing Failed Changing monitoring state from "Operational" to "Error"

When Octoprint receives the error it halts the system.

Happens with either the "bugfix-2.1.x-F4-s1pro_ubl100" or "2.1.2-ender-3-s1-F4-s1pro_ubl100" versions.

synman commented 1 year ago

Tweak Octoprint to not fail / halt on all errors. This is what I do.

MrDB42 commented 1 year ago

Oh... That's cheating! ;)

I was starting to wonder if my probe was the issue. But if you're running into the same problem, I wonder what the root cause of the errors are?

MrDB42 commented 1 year ago

And... even if I disconnect via Octoprint, running the bed level from the LCD screen, it will eventually lock up completely.

It gets to 100%, then it starts over and hangs at 3%. Weird.

The UBL25 works just fine, BTW.

synman commented 1 year ago

Have you read the UBL discussion? Check it out if not as it gives a ton of pointers.

My guess is it's the CR touch flaking out and / or an upstream bug in Marlin.

You're going to find a couple scenarios where Marlin will issue an error where you don't want Octoprint to disconnect. There are a couple options there you'll want to look at.

synman commented 1 year ago

Let's move this to the UBL discussion thread