search

synman / Octoprint-Bettergrblsupport

Better Grbl Support Plugin for Octoprint based (loosely) on the original Grbl Support plugin developed by mic159
https://github.com/synman/Octoprint-Bettergrblsupport/wiki
64 stars 19 forks source link

Missing Tabs after switching to 3d-printer #85

Closed andreasthaler1966 closed 1 year ago

andreasthaler1966 commented 2 years ago

Discussed in https://github.com/synman/Octoprint-Bettergrblsupport/discussions/84

Originally posted by **andreasthaler1966** July 31, 2022 Hi! I just installed the GREAT plugin on my PI, wich I normally use for a 3D-Printer. Now I wanted to switch back to the 3D-Printer (by disabeling the plugin). Now my #control, #temp and #gcode - tabs disappeared. I hope this is the correct channel to question...
synman commented 1 year ago

I think I saw this over in the discussion section. Let me hop back over there and pull in my answer here.

synman commented 1 year ago

https://github.com/synman/Octoprint-Bettergrblsupport/discussions/84

This is going to get the "will not fix" tag for now as I have no means of detecting when the plugin is disabled / re-enabled.

synman commented 1 year ago

this will go out with 2.2.2 in the next week or so. I figured out how to trap plugin disable

andreasthaler1966 commented 1 year ago

Super!Thank you!--Diese Nachricht wurde von meinem Android Mobiltelefon mit GMX Mail gesendet.Am 12.11.22, 08:20 schrieb "Shell M. Shrader" @.***>:

this will go out with 2.2.2 in the next week or so. I figured out how to trap plugin disable —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you authored the thread.Message ID: @.***>