search

synthetos / g2

g2core - The Next Generation
Other
633 stars 296 forks source link

g2command reject #202

Open alessandrolecce opened 7 years ago

alessandrolecce commented 7 years ago

if start from x0y0 and send g2x0y0i1j0 command are reject. Why?

giseburt commented 7 years ago

Could you provide some more information? Hardware and configuration used, what exactly are you sending and what exact errors are you getting back?

alessandrolecce commented 7 years ago

223

alessandrolecce commented 7 years ago

Arduino due

[fb] firmware build 100.18 [fbs] firmware build "" [fbc] firmware config "settings_default.h" [fv] firmware version 0.99 [hp] hardware platform 3.00 [hv] hardware version 0.00 [id] g2core ID 0084-d639-18c6-18c [jt] junction integrgation time 0.75 [ct] chordal tolerance 0.0100 mm [sl] soft limit enable 0 [0=disable,1=enable] [lim] limit switch enable 1 [0=disable,1=enable] [saf] safety interlock enable 1 [0=disable,1=enable] [m48e] overrides enabled 1 [0=disable,1=enable] [mfoe] manual feed override enab 0 [0=disable,1=enable] [mfo] manual feedrate override 1.000 [0.05 < mfo < 2.00] [mtoe] manual traverse over enab 0 [0=disable,1=enable] [mto] manual traverse override 1.000 [0.05 < mto < 1.00] [mt] motor idle timeout 2.00 seconds [spep] spindle enable polarity 1 [0=active_low,1=active_high] [spdp] spindle direction polarity 0 [0=CW_low,1=CW_high] [spph] spindle pause on hold 1 [0=no,1=pause_on_hold] [spdw] spindle dwell time 1.0 seconds [ssoe] spindle speed override ena 0 [0=disable,1=enable] [sso] spindle speed override 1.000 [0.050 < sso < 2.000] [cofp] coolant flood polarity 1 [0=low is ON,1=high is ON] [comp] coolant mist polarity 1 [0=low is ON,1=high is ON] [coph] coolant pause on hold 1 [0=no,1=pause_on_hold] [tv] text verbosity 1 [0=silent,1=verbose] [ej] enable json mode 0 [0=text,1=JSON,2=auto] [jv] json verbosity 2 [0=silent,1=footer,2=messages,3=configs,4=linenum,5=verbose] [qv] queue report verbosity 1 [0=off,1=single,2=triple] [sv] status report verbosity 1 [0=off,1=filtered,2=verbose] [si] status interval 250 ms [gpl] default gcode plane 0 [0=G17,1=G18,2=G19] [gun] default gcode units mode 1 [0=G20,1=G21] [gco] default gcode coord system 1 [1-6 (G54-G59)] [gpa] default gcode path control 2 [0=G61,1=G61.1,2=G64] [gdi] default gcode distance mode 0 [0=G90,1=G91]