cmcgrath5035
commented
4 years ago FW 440.20 says you are running tinyG, not G2. Repost at https://synthetos.com/forums/tinyg/tinyg-support or, if you want, https://github.com/synthetos/TinyG/issues
Open tbs845 opened 4 years ago
cmcgrath5035
commented
4 years ago FW 440.20 says you are running tinyG, not G2. Repost at https://synthetos.com/forums/tinyg/tinyg-support or, if you want, https://github.com/synthetos/TinyG/issues
Hello, I am having an issue the PCB Auto Level feature. Physically, it trips out as soon as the z axis goes to lift up after the first probe. I am on firmware version 440.20.
I changed the limit switches to be normally open and have checked it in the setting also. I did this due to the auto level feature detecting the closed contact yesterday as soon as it started probing from +0.5mm, which makes sense in my mind. It did complete a full prob run, just +0.5mm across the board.
I have attached a txt file of the command line log of my latest attempts. I am providing a max negative z value of -10mm incase I was outside the range and that was causing an issue.
Any help would be appreciated. PCB_Probing_Error.txt