Solar settings for Start/Stop Temp Delta do not get sent to OCP

tagyoureit / nodejs-poolController

An application to control pool equipment from various manufacturers.

GNU Affero General Public License v3.0

315 stars 94 forks source link

Solar settings for Start/Stop Temp Delta do not get sent to OCP #380

Closed johnny2678 closed 2 years ago

johnny2678 commented 2 years ago

I'll change the settings in dash (e.g. 5/2) but the settings don't get committed in the OCP (Easytouch 2 4 in my case)

rstrouse commented 2 years ago

Can I get you to pull njsPC and dashPanel. Then using either ScreenLogic, wireless controller, or an indoor control panel change these values while capturing a replay. Finally, post that replay capture here so I can examine what the message handshake looks like.

johnny2678 commented 2 years ago

There doesn't seem to be any place to change this aside from the OCP - don't see any settings in screen logic and I don't have an indoor panel. Hope changing them at the OCP is sufficient. If so, replay attached...

I changed the start temp to 5 and stop temp to 2 replay (29).zip

rstrouse commented 2 years ago

Oh wow that explains a lot. I have recently looked at the settings for UltraTemp heaters and it appears these also can only be set on the OCP. I think I need to find somebody who forked out the cash for the ICP or the WCP.

johnny2678 commented 2 years ago

I do have one of those white Easytouch branded pool remotes. Is that a WCP?

Anyway, popped in some fresh batteries, went to the panel to sync the addresses and then remembered why I let it sit and collect dust. It shows time/temp/mode but anytime you click into settings or turn on a circuit it says "communications lost"

Back to the closet it goes...

rstrouse commented 2 years ago

Yes that is a WCP (wireless control panel) ... bummer.

tagyoureit commented 2 years ago

Closing this as it appears we can't actually control these deltas.