Open otto76 opened 2 years ago
How does the output of the KeybusReader
sketch look? Any garbled data or CRC errors? There shouldn't be spurious messages, if you're seeing things like 0x10: "Keypad lockout"
without activity from keypads, I'd suspect a wiring issue or component fault.
I've seen that type of issue with 05 commands that lose a bit possibly due to a bad connection or noisy line. That changes the message quite a bit and can give you all kinds of odd statuses. Unfortunately the 05/1b commands don't have a CRC checksum to validate a good command, this is tricky to filter out. A solution I'm testing is to always wait for 2 identical commands before accepting it as valid. This works with the 05/1b since they are constantly being sent.
Hey, cannot figure out why system time to time is sending ExitDelay message, even its not expected
There is no specific pattern when it happens, either regular time gaps or specific actions done before, nor dedicated messages received. I have seen weird messages, like 0x10: "Keypad lockout"; time to time, but not directly related to Exit delay.
Any ideas why this message can be pushed
Running on mega 2560 pro mini with W5500 Chip based Ethernet (Voltage is stable and in workable range, the same for DSC interface)
The piece of code in loop:
And message publisher: