Quality control of 3rd party produced PCBs is variable. Some versions are taller than expected and with the supplied carrier do not fit in the Stealthburner front housing. Troubleshooting this unknown fitment issue broke the LED lens, wire connections to the PCB, and the SB front housing. If a deeper carrier had been available, I could have avoided this. So, I edited rev2.
Changes: Altered inset area of carrier to accommodate taller solder pads on LED board. The inset area has been carved out sufficiently to allow the thicker PCB to sit with LEDs flush.
Quality control of 3rd party produced PCBs is variable. Some versions are taller than expected and with the supplied carrier do not fit in the Stealthburner front housing. Troubleshooting this unknown fitment issue broke the LED lens, wire connections to the PCB, and the SB front housing. If a deeper carrier had been available, I could have avoided this. So, I edited rev2.
Changes: Altered inset area of carrier to accommodate taller solder pads on LED board. The inset area has been carved out sufficiently to allow the thicker PCB to sit with LEDs flush.