I loaded the firmware 9.1.0 (sensors) on a D1 MINI to be able to use it with the PZEM-004 V3
I have configured the D1 in the following way:
Tx GPIO01 -> PZEM0xx TX
Rx GPIO03 -> PZEM004 RX
But with this configuration I was not able to get any reading from PZEM004
I changed Rx GPIO03 like this: PZEM016 Rx and by doing so I was able to get readings from the device.
I loaded the firmware 9.1.0 (sensors) on a D1 MINI to be able to use it with the PZEM-004 V3 I have configured the D1 in the following way: Tx GPIO01 -> PZEM0xx TX Rx GPIO03 -> PZEM004 RX
But with this configuration I was not able to get any reading from PZEM004
I changed Rx GPIO03 like this: PZEM016 Rx and by doing so I was able to get readings from the device.
Why does this happen?
Thank you very much