search

tasmota / mgos32-to-tasmota32

ESP32 Mongoose OS to Tasmota32 OTA updates for Shelly
GNU General Public License v3.0
153 stars 10 forks source link

Shelly Plus Wall Dimmer #17

Open kunaalm opened 11 months ago

kunaalm commented 11 months ago

I am attempting to migrate a Shelly Plus Wall Dimmer to Tasmota (I know it's untested!). I don't see any GPIO mapping after autoconfig. Is the template known / defined somewhere?

Jason2866 commented 11 months ago

You are the first. So no.

tkffaul commented 5 months ago

I have one as well that I would like to convert. I have the boot loader up and running but still no GPIO mapping?

Jason2866 commented 5 months ago

Since no feedback from users which have the device how the GPIOs are assigned, I can't add them.

tkffaul commented 5 months ago

I know this is probably more involved, but I'm not a complete noob... can you guide me on how to check GPIO and maybe I can help provide a map? I have a temporary rig setup for this already, i have a serial over USB connector I can hook on to it... I just don't know how to proceed to map the pin sets.

Jason2866 commented 5 months ago

Without open the device this can be a useless attempt. If dimming is done via a second MCU the train stops here. In this case a complete reverse engineering is needed or a dimming firmware needs to be done. Like it was done for the Shelly Dimmer. If all work is done by the ESP32 the journey goes on :-)

tkffaul commented 5 months ago

So if i crack the case and take some photos, that would be helpful? I know shelly has stated that this is very different than the original dimmers... so (just an assumption) i think it might do everything from the ESP32 now.

Jason2866 commented 5 months ago

Yes, photos will help. So no guessing about "who" does the dimming. Maybe it can be seen which GPIOs goes to the FETs (when the ESP32 does everything)

tkffaul commented 5 months ago

IMG_4017 Back of Switch

tkffaul commented 5 months ago

IMG_4018 Inside

tkffaul commented 5 months ago

IMG_4024 Zoom in of the ESP32

tkffaul commented 5 months ago

IMG_4023

tkffaul commented 5 months ago

IMG_4025 IMG_4026 IMG_4027

tkffaul commented 5 months ago

Hope that helps!

Jason2866 commented 5 months ago

Yes, it does help. I think this IC is an MCU

Bildschirmfoto 2024-04-25 um 11 04 07

since it is placed on the AC power PCB it probably does the dimming job and the ESP32 "just tells" to do so. Did not find any data sheet for this IC

Looks like flashing Tasmota does lead to nowhere. Thx for the photos!!

RavenSystem commented 5 months ago

It is an STM32S003. Best way is to use a logic analyzer to read UART communication between ESP32 and it, with the original Shelly firmware loaded, of course.