Hardware process documentation

This was my first time install so followed instructions, thanks. Couple of suggestions:

Access to PCB is really easy - 4 mains screws under the base.
I removed the WiFI panel cable (carefully as these connectors often break) which made it easier.
Use of 'plugin' - this means 'plug power in' (I had stupidly thought I powered via the connector)
Mating a standard PCB header with a connector viable F-F ribbon cable to the USB adapter makes a robust way of holding the GND/TX/RX pins in place whilst programming.
Small fine tip tweezers make the shorting of the program pins easy

I thought it might be helpful to have a picture of the PCB (though your instructions were quite clear). Attached in case you want to use it !

Thanks again for doing this, Winston is very happy !

35E28488-3200-46D8-9DA1-61CED84B6404_1_105_c

taylorfinnell / petlibro-esphome