Was working on designing a mount for my TBS Source One V4 and discovered a rather annoying thing whereby the inner main frame standoffs have two different offsets from center (center being the center of the 30.5x30.5 stack mounts), that being 32.25mm and 37.05mm front/back respectively.
I have not checked the V5 yet (I don't own one yet :) ) so apologies if this particular gremlin is already fixed in V5.
Please also provide PDF drawings showing the locations, sizes and offsets for your mounting holes too as it would make designing accessories a lot easier.
Whilst the DXFs do work, if you don't have high end CAD tools (or know how to use the open source ones in my case) deriving the measurements from DXF is a very fiddly and time consuming endeavor.
Was working on designing a mount for my TBS Source One V4 and discovered a rather annoying thing whereby the inner main frame standoffs have two different offsets from center (center being the center of the 30.5x30.5 stack mounts), that being 32.25mm and 37.05mm front/back respectively.
I have not checked the V5 yet (I don't own one yet :) ) so apologies if this particular gremlin is already fixed in V5.
Please also provide PDF drawings showing the locations, sizes and offsets for your mounting holes too as it would make designing accessories a lot easier.
Whilst the DXFs do work, if you don't have high end CAD tools (or know how to use the open source ones in my case) deriving the measurements from DXF is a very fiddly and time consuming endeavor.
Cheers!