Ender 3 with Sonic Pad, firmware updated Saturday.
I tried to run a speed test, but got a "Move exceeds maximum extrusion (3.280mm^2 vs 0.640mm^2)" error before the printer started the speed test model. I have run a Benchy with speeds up to 210mm/s, generated by Cura. The speed test gcode from the printer calibration site was up to 175mm/s. I went back over the perameters I entered for the speed test, and I don't see anything that I entered wrong.
I did some internet searches, and found a few cases of this error message, but the solutions revovled around changing code in the firmware. I don't want to do that if gcode from the slicer works.
Ender 3 with Sonic Pad, firmware updated Saturday. I tried to run a speed test, but got a "Move exceeds maximum extrusion (3.280mm^2 vs 0.640mm^2)" error before the printer started the speed test model. I have run a Benchy with speeds up to 210mm/s, generated by Cura. The speed test gcode from the printer calibration site was up to 175mm/s. I went back over the perameters I entered for the speed test, and I don't see anything that I entered wrong.
I did some internet searches, and found a few cases of this error message, but the solutions revovled around changing code in the firmware. I don't want to do that if gcode from the slicer works.