When slicing today I found an extra wall being printed. A bit confused I found out there is a setting called Alternate Extra Wall within Cura. This setting was enabled for me by default which caused the issue. It wasn't visible until I enabled the setting expert view.
Default voron 2.4 'fast' profile with generic pla (unsure what others it will affect). Thankfully I'm expierenced enough now to spot the issue. However, when I first started printing I don't think I would of been able to solve it by myself, thus I'm suggesting to add a foot note to ensure the setting is disabled when slicing (maybe a screenshot of the preview too to make it clearer what's happening)
When slicing today I found an extra wall being printed. A bit confused I found out there is a setting called
Alternate Extra Wallwithin Cura. This setting was enabled for me by default which caused the issue. It wasn't visible until I enabled the setting expert view. Default voron 2.4 'fast' profile with generic pla (unsure what others it will affect). Thankfully I'm expierenced enough now to spot the issue. However, when I first started printing I don't think I would of been able to solve it by myself, thus I'm suggesting to add a foot note to ensure the setting is disabled when slicing (maybe a screenshot of the preview too to make it clearer what's happening)