Soldering odd jobs

[GoogleCodeExporter]

1. Gertboard 5 volt rail brake out
2. Shield - all pins that remain
3. battery container - wires and switch

Others maybe added at a later date.

Original issue reported on code.google.com by cian.by...@sydstu.catholic.edu.au on 19 Dec 2012 at 11:45

[GoogleCodeExporter]

I can do the gertboard job but are you sure its ready to replace your Arduino? 
If so then I will solder all the headers onto the H-Bridge shield. The battery 
container can be done "in due season" ;)

Original comment by cmdenterpriseshq on 20 Dec 2012 at 1:49

• Changed state: Accepted

[GoogleCodeExporter]

Lets make this happen either on 22nd (tomorrow) or on the 23rd (SUNDAY, at the 
party).

You know how you wanted an 'excuse' to come down to Cammeray, now you have one! 
:D

Original comment by cian.by...@sydstu.catholic.edu.au on 21 Dec 2012 at 11:55

[GoogleCodeExporter]

I will go to Jaycar tomorrow some time to buy more headers.  I need to work-out 
how many I need.

I shall respond here in due course.

EDIT:
Number of Pins on each device.
- 37 on the shield
- 10 to 15 on the Gertboard (4 minimum)
- Two wires on the battery box (one (+) and surprise, surprise, one (-))

Let me know when you wish to complete the above jobs.  Keep in mind that the 
21st of December 2012 (In america, because the Mayan's lived in America...) 
ends on the 22nd of December 2012 in Australia at about 7pm AEST.  Please have 
the job done before that happens :D :D :D :D.  #yolo #endoftheworld 
#http://www.telegraph.co.uk/news/worldnews/maya/9758201/Mayan-apocalypse-the-end
-of-the-world-live.html  

Original comment by cian.by...@sydstu.catholic.edu.au on 21 Dec 2012 at 12:06

[GoogleCodeExporter]

Hahaha the world has actually already ended, we are living in a matrix of the 
truth :D on to the subject at hand however: I will do all jobs at the byrne 
party (or before :D) Ive got a few headers here but ill have to count to see 
how many, cause ive used/need to use a few. If you supply wires for battery box 
then I will solder :D :D :D remind me to bring a toggle switch so we can easily 
cut voltage and/or be able to switch between 12V/24V perhaps a future update :) 
while you're up there can you get me some blue screw terminals cause I need a 
couple more for the h-bridge chip :P

Original comment by cmdenterpriseshq on 21 Dec 2012 at 12:21

[GoogleCodeExporter]

Can I start a new topic?  Move all Jaycar requests to there.

Original comment by cian.by...@sydstu.catholic.edu.au on 21 Dec 2012 at 12:27

[GoogleCodeExporter]

All have been completed.  Thank You Tom!  :D

Original comment by cian.by...@sydstu.catholic.edu.au on 24 Dec 2012 at 10:52

• Changed state: Done