search

tesla-android / issue-tracker

Place for reporting issues and discussion with the community
18 stars 1 forks source link

Unable to complete Android deploy #25

Closed davepalmeruk closed 2 years ago

davepalmeruk commented 2 years ago

Hi there.

I am having an issue writing the android image to my Pi4 (8GB model). Stock except previously used Pi Config tool to set boot mode to USB > SD order, yet only an SD card is in use.

Able to follow steps 1-8 in via Windows OK, write files via Fastboot, 2 reboots awaiting each time to see Pi get back to bootloader or fastboot. Last reboot.

Bootloader is shown, yet not the output as shown on step 9. Attached picture of what I see briefly. Then screen goes blank (monitor power saves) and no further activity for 30+ mins.

IMG_1240 .

davepalmeruk commented 2 years ago

Closing as resolved. First attempt to boot was using the PC powered USB A > USB-C connector on the Pi4 as used to run fastboot commands. Powered off and powered on again using official power brick and now it's booting with the same message then followed by Android boot logo and progress. Unsure yet maybe too little power? Thanks.