search

tetrabiodistributed / papra-pcba

Printed Circuit Board Assembly (PCBA) for the PAPPRa m12 controller
Other
2 stars 2 forks source link

Papra PCB engineering drawing #15

Closed mmroden closed 3 years ago

mmroden commented 3 years ago

Please submit an engineering diagram in PDF, PNG, whatever makes sense.

Bonus points for a soldering jig.

darraghbr commented 3 years ago

A-TET- Papra Control PCBA Drawing.pdf

@mechatroniks-git Please review when able.

mechatroniks-git commented 3 years ago

Looks nice. A few comments:

  1. The board, as it comes from JLC should have the fuse installed, no need to point that out.
  2. The PCB should have a balloon
  3. Washers & Nuts included with the potentiometer and DC jacks - not sure if they should be separate line items?
  4. Lightpipe is already on the M12 controller BOM? It should only be on 1 BOM, probably the other one, as it needs to be assembled with the board, after the board is installed.

image

darraghbr commented 3 years ago

Please see attached, I believe I have dealt with all of your comments.

Aside from the nuts and washers appearing on the BOM, Because they are seperate components there isn't a nice way to not have them visible on the BOM and also have them visible on the drawing. I can remove them from the drawing and BOM if desired.

D-TET-.Papra.PCBA.Drawing.pdf

mechatroniks-git commented 3 years ago

LGTM

darraghbr commented 3 years ago

@mmroden please review when able.

mmroden commented 3 years ago

Man, this is phenomenal!