waterproof/splashproof the papra? How to do that?

tetrabiodistributed / papra-pcba

Printed Circuit Board Assembly (PCBA) for the PAPPRa m12 controller

Other

2 stars 2 forks source link

waterproof/splashproof the papra? How to do that? #34

Closed mmroden closed 3 years ago

darraghbr commented 3 years ago

We could use a set of louvres on the fan box to hopefully keep the worst of any rain etc off the filter pack.

It may limit which orientation you can mount the fan box.

darraghbr commented 3 years ago

For the M12 controlled we could use a 3D printed TPU or other flexible gasket that seals between the battery and the M12 housing. The lid could then be attached permanently with a waterproof adhesive and IP rated potentiometers and DC jacks utilised.

darraghbr commented 3 years ago

An example of the louvers is something like what are used on armoured fighting vehicles to protect the radiators and air intakes.

They are also used on dirt bikes to protect the radiator from debris.

mmroden commented 3 years ago

Handled by #37 and #38 in this project

mmroden commented 3 years ago

redundant to #55 and work done in the papr-print-files