thamoscorp / minimosd-extra

Automatically exported from code.google.com/p/minimosd-extra
0 stars 0 forks source link

firmware boots, can see attitude change but no data in numerical fields + virtual horizon is broken #32

Closed GoogleCodeExporter closed 9 years ago

GoogleCodeExporter commented 9 years ago
What steps will reproduce the problem?
1. flash using CT for MinimOSD Extra 2.2
2. use MinimOSD Extra Plane 2.2.hex firmware 
3. use OSD_charset.mcm
4. setup APM 2.5 with arduplane 2.7.3 with wiki instructions 
https://code.google.com/p/minimosd-extra/wiki/APM
5. connect and boot up

What is the expected output? What do you see instead?
I expected everything to boot up and show data fields selected after firmware 
update in the tool. I expec virtual horizon to look like a line made of dashes.

I see: after booting up I can see virtual horizon respond but no data in any 
other field. Virtual horizon responds, but instead of dashes I see either 
nothing or some gibberish in their place. but everything moves according to APM 
orientation perfectly well. I had the same problem with minimosd (without 
extra) firmware,I saw horizon, gps status and mode but no numeric field like 
speed or heading or altitude.

What version of the product are you using? On what operating system?
    CT for MinimOSD Extra 2.2 tool
        MinimOSD Extra Plane 2.2.hex firmware

Please provide any additional information below.
APM 2.5 with arduplane 2.7.3.

Here is a link to a video I made describing this problem. This is minimosd 
firmware, but the situation is 100% the same. same APM setup, same board, all 
setup according to this wiki.

Original issue reported on code.google.com by KSetde...@gmail.com on 17 May 2013 at 9:51

GoogleCodeExporter commented 9 years ago
Forgot a link to the video( Here is the issue. It is a different firmware, but 
behavior is 100% the same. 
http://www.youtube.com/watch?v=qUlTCdfc3Lo

Original comment by KSetde...@gmail.com on 17 May 2013 at 9:52

GoogleCodeExporter commented 9 years ago
Hi,

Does it works now?

It is important, that you use the right character set and CT forthe FW you use.
It will not work if this 3 criteria does not met.

Also check your SR parameters: https://code.google.com/p/minimosd-extra/wiki/APM

Original comment by gabek...@gmail.com on 1 Jun 2013 at 10:48

GoogleCodeExporter commented 9 years ago

Original comment by gabek...@gmail.com on 31 Jul 2013 at 12:14