Open wayneSt0ck opened 3 years ago
I wish I still had access to the laser engraver to help. Unfortunately I don't work at the engraving shop I did any longer, and live about an hour away from there. (it's difficult to troubleshoot something that is not physically with you) Best of luck to you on this.
Ahh, I was hoping you remembered the process from back then especially the driver selection portion.
Anyways, thanks for the reply! I will keep trial and erroring things.
wayneStock
If you have anything to share about your findings, please share and I will add to the repo!
If it has been too long, no worries, but if anyone is still looking at this project, I have a question regarding drivers portion of cups.
Just going through the setup. 1) I add a printer 2) I setup a local printer (epilog laser, this red lines vector cut) 3) I use epilog://laserIP/Legend/rp=75/rs=95/vp=100/vs=10/vf=5000/rm=mono/grey/colour as connection name 4) Setup name/desc/location and check share printer 5) Then is brings me to the driver section. I cannot move on without choosing a make and drive. I thought using Generic PostScript would work, but it does not appear to be doing anything.
Any help would be great!
wanyeStock