What steps will reproduce the problem?
1. Initially, Sk1 was installed from source on Debian Wheezy,
kernel 2.6.39-5-686-pae
2. After installation (on July), i imported a drawing made on corel X2
3. I made some changes to the drawing, and saved it as Sk1
4. On August, i made the kernel upgrade to 3.0.0-1-686-pae
5. i opened the sk1 file, clicked file, save as..., export to, or print to pdf
6. Sk1 quits without a visible message; in the case of save as... and export to
menus, i can chose name, destination and output format, on the file widget
displayed.
What is the expected output? What do you see instead?
i checked the syslog, and found this error
kernel [ 3181.363277] sk1[6776]: segfault at 0 ip b6d7e76a sp bfcf0ba0 error 4
in libtk8.5.so.0[b6cae000+125000]
i already compiled again all the sk1 modules.no success
What version of the product are you using? On what operating system?
Debian GNU/Linux Wheezy, 3.0.0-1-686-pae
Sk1 and dependencies compiled from
sk1libs-0.9.2pre_rev1383.tar.gz
sk1sdk-0.9.1pre2_rev1383.tar.gz
sk1-0.9.1pre2_rev1383.tar.gz
Uniconvertor:
uniconvertor-1.1.5.tar.gz
uniconvw-1.1.5.tar.gz
Python
Python 2.6.7 (r267:88850, Jul 10 2011, 09:55:27)
[GCC 4.6.1]
Please provide any additional information below.
if you need it, i can send you
via PM, the sk1 file
best regards
Hector Garcia
Original issue reported on code.google.com by HectorOG...@gmail.com on 2 Sep 2011 at 6:30
Original issue reported on code.google.com by
HectorOG...@gmail.comon 2 Sep 2011 at 6:30