802.11n doesnt work

[GoogleCodeExporter]

Please describe the problem in detail. Be sure to include:

What steps will reproduce the problem?
when it tries to use wifi (802.11n) 

What is the expected output? What do you see instead?

Connet wifi with 802.11n i can only connect trough wifi over 802.11b/g

What version of aospX are you using? And when did the issue first start?
Since i installed MR1 wifi by 802.11n stopped to work. 

Please list the kernel version under Settings->About phone

2.6.35.14-aospx-mint_chocolate

Does the issue happen after a full wipe and without any data restored?
It doesnt

Inspire4G or DesireHD? (If Inspire, did you flash Inspiremod?)
Inspire4g , inspiremod flashed.

Please provide logcat ouput and any additional information below.
(logs required or I will discard the ticket.)

Original issue reported on code.google.com by pablitom...@gmail.com on 9 Oct 2012 at 10:11

[GoogleCodeExporter]

[deleted comment]

[GoogleCodeExporter]

This is an invalid bug report.

Also, this is not a bug, its just with AOSP only A/B/G is supported by default. 
But ill look into what needs to be done for N. But technically this is not a 
bug.

Original comment by robbe...@gmail.com on 10 Oct 2012 at 4:18

[GoogleCodeExporter]

i would like to add that with the las version BR7  "N" worked perfectly. 

Original comment by pablitom...@gmail.com on 10 Oct 2012 at 4:35

[GoogleCodeExporter]

Ive added N firmware to available wifi bands for next release and im able to 
set my router to N only and connect fine (our source was only setup for A/B/G 
in all previous aospX releases). But either way, it should be working in next 
release regardless. 

Also, the reason I marked this invalid was due to no debug logs. If something 
worked in a previous release, then not in a new one, I must have debug logs of 
before and after. Theres really not much I can do without debug logs, my 
initial guess is usually as good as yours.. If the problem continues after next 
release, then feel free to open a new ticket along with logs of it from BR7 (if 
it worked then), and then logs of the new release (if its not working then) so 
they can be compared.

Original comment by robbe...@gmail.com on 10 Oct 2012 at 5:35

[GoogleCodeExporter]

I've run MR1 on N-only and B/G/N networks. Flawlessly in both cases.

Original comment by s.imph...@gmail.com on 19 Oct 2012 at 4:26