Open dwikoUP opened 6 years ago
@dwikoUP
try: 1- u-blox Ucenter.exe to config your 6t to outpur raw data. ( carrier phase and ephemeris) 2- disable NMEA sentences. ( useless for RTKLIB ) 3- save settings into receiver NVRAM
btw: your shutdown commands are for Novatel receiver.
good luck !
Thank you for your reply @yjmenezes .
I tried to configure the input and output in U-Center, but still failed. This how I configured in U-Center.
Message option
Port
But STRSVR still could not get the measurement.
I solved the problem! Just install the the ublox VCP driver, this is the link: https://www.u-blox.com/sites/default/files/ubloxGnss_vcpDeviceDriver_windows_3264_v3.10.exe
It is because the receiver is detected as a SENSOR not a USB, so it has no PORT. After install the VCP driver, then the port will be appeared.
Hello everyone, I am a beginner in RTKlib, and I have a problem in getting measurement data using STRSVR. I use Ublox Lea 6t-1-001 and antenna ANN-MS-0-005. This is the picture as I click the start button, there are error message: (0) device open error (2).
I have followed the manual or instruction, and these are how I set the configuration.
Serial Options in Input:
Serial/TCP Commands in Input:
Conversion Option in (1) Output:
After I click the Start button, it is always failed. I have know idea why STRSVR could not retrieve the measurement data. I really need help to overcome this problem. Thank you.