Open bavery79 opened 11 months ago
will do some further investigation to see if these can be enabled without major rewrites of the code
I see I was apparently mistaken about autoaddpurge and it actually dies already work in the default mode with prusa generated wipe tower. Could have sworn this wasn't the case a few months ago, but might have been user error on my part. :-)
I see I was apparently mistaken about autoaddpurge and it actually dies already work in the default mode with prusa generated wipe tower. Could have sworn this wasn't the case a few months ago, but might have been user error on my part. :-)
Nevermind, it seems I spoke too soon! New PP2P version now shows a confirmation that autoaddpurge has been disabled due to incompatibility. Perhaps the older PP2P version just wasn't showing the notification?
Autoaddpurge can only be done with self-genrrated purge towers. I need control over where to purge the filament Will think about a way to resolve this but nothing comes to mind right now
On 12 Aug 2023, at 07:48, bavery79 @.***> wrote:
I see I was apparently mistaken about autoaddpurge and it actually dies already work in the default mode with prusa generated wipe tower. Could have sworn this wasn't the case a few months ago, but might have been user error on my part. :-)
Nevermind, it seems I spoke too soon! New PP2P version now shows a confirmation that autoaddpurge has been disabled due to incompatibility. Perhaps the older PP2P version just wasn't showing the notification?
— Reply to this email directly, view it on GitHub https://github.com/tomvandeneede/p2pp/issues/172#issuecomment-1675722966, or unsubscribe https://github.com/notifications/unsubscribe-auth/AK6CHJMKZNHAF5TDVJY7RJ3XU4KLPANCNFSM6AAAAAA265J6VI. You are receiving this because you commented.
Moving from P2 to P3P (with a Klipper-based printer) recently, I find myself missing a lot of the extra functionality allowed by the FULLPURGEREDUCTION mode that I had been using regularly with my Palette 2S. Ran across a closed issue regarding Accessory Mode not able to support any of the P2PP-generated wipe tower modes and would like to add my 2-cents.
On a related note, I would love to see an ability to take advantage of those extra functions I've enjoyed (specifically WIPEFEEDRATE & AUTOADDPURGE) in something like the tower delta mode (ideally with accessory mode support for klipper but I understand this circles back to request #1 above), so a user could for example set a delta of 0 and then be able to get a tower built right next to the printed model while still being able to use AUTOADDPURGE and WIPEFEEDRATE features. Or maybe it could be as simple as - if you try to enable one of those features with the default Prusa-generated wipe tower P2PP could just auto-switch to generate its own tower. Basically, anything to make AUTOADDPURGE useable with a more "default" setup of P2PP I think would add greatly to useability and give one less thing to have to worry about when setting up prints.