I have tried your image on my my pi model b and it boots fine. After the first boot where it expands the file system and finalizes the setup it reboots and waits at the login prompt. When I connect to ps2 opl and setup my network settings from that side it continuously gives error 300 or 301. I have checked the network settings over and over. I have tried 3 different cat5 cables plus a crossover cable all cables checked using a network lead tester. I just finished crimping a new lead that I've made myself to be short about 10cm (checked working with cable tester) and that makes zero difference. I have tried this on 2 x PS2 FAT devices and a PS2 Slim and it still errors. Also tried writing the image to multiple SD cards with the same resuts on all PS2 devices. I then tried the image on my Raspberry Pi 400 and Zero 2 and they wont even boot the image no matter the SD card (Both devices work absolutely fine with other os images). I am pulling my hair out trying to work out what is going wrong or what I have done wrong but I've been through the tutorial serveral times and it always end the same way. The tutorial gets it working but it does not work from my end.
Can you please offer any advice? Is there a prebuilt image for the pi 4/400/zero/zero2 I can try just to make sure smb share is working ?
I have tried your image on my my pi model b and it boots fine. After the first boot where it expands the file system and finalizes the setup it reboots and waits at the login prompt. When I connect to ps2 opl and setup my network settings from that side it continuously gives error 300 or 301. I have checked the network settings over and over. I have tried 3 different cat5 cables plus a crossover cable all cables checked using a network lead tester. I just finished crimping a new lead that I've made myself to be short about 10cm (checked working with cable tester) and that makes zero difference. I have tried this on 2 x PS2 FAT devices and a PS2 Slim and it still errors. Also tried writing the image to multiple SD cards with the same resuts on all PS2 devices. I then tried the image on my Raspberry Pi 400 and Zero 2 and they wont even boot the image no matter the SD card (Both devices work absolutely fine with other os images). I am pulling my hair out trying to work out what is going wrong or what I have done wrong but I've been through the tutorial serveral times and it always end the same way. The tutorial gets it working but it does not work from my end.
Can you please offer any advice? Is there a prebuilt image for the pi 4/400/zero/zero2 I can try just to make sure smb share is working ?