Closed jaseg closed 6 years ago
It would. I'll check my receipts and close this issue when it's documented.
Greetings neighbors, I opened up my 3208 and measured the board thickness at 0.5mm. The picture on https://github.com/travisgoodspeed/goodwatch/wiki/GoodWatch10 has them looking very close in thickness.
I manufactured in .024" (~0.61mm), but 0.5mm would fit better if your manufacturer allows it.
Close this issue when the documentation is updated.
My boards manufactured in 0.6mm fit snugly in the enclosure of a CA53W-1 watch. Since 0.6mm thickness is the thinnest commonly available from cheap PCB fabs, perhaps it should be the recommended value for this project.
Fixed in 37d6f73 with the GoodWatch21 schematic.
Awesome project! What thickness are the PCBs though? Standard 1.6mm sounds a bit much to me. I think it would make sense to list this in the BOM.