search

trexminer / T-Rex

T-Rex NVIDIA GPU miner with web control monitoring page
2.63k stars 438 forks source link

Mclock command not working on 3060ti LHR #837

Open RickyWinardy opened 2 years ago

RickyWinardy commented 2 years ago

Hi, I am using 3060ti LHR mining eth. My oc (memory clock especially) is working fine when I use Msi afterburner. I put it on +800. I can get around 43-44mhs. But when I try to set mclock on bat file with value: 800, it only give me around 34mhs, and when started the LHR target hashrate is only 34mhs too. If I put it higher (ex. 1000), it will be crash like it should be like when I put +1000 on msi afterburner. Why mclock command on trex bat file seems like not working on this card, while it is working fine on other card.

thanks for answer

wangzeming666 commented 2 years ago

Hi, I am using 3080 LHR mining eth. I have the same problem with the up one. My os is working fine when I use Msi afterburner. But when I try to set mclock on bat file with value: 1500, it doesn't have any promote. Then I use Msi afterburner and set the memery to 107000 during the eth-miner still running. And the frequency of memery is promoted successfully. As usual, the t-rex will reset the frequency with the parameters setting in the bat file. But this time, it doesn't. So I guess this problem is caused by memery setting function losing.

Thanks for reading.

RickyWinardy commented 2 years ago

And it seems only problem for LHR card I guess? My other gpu card (1660s and 1660ti) is working fine with mclock setting in bat file of trex.